|
|
#1
09-03-2009, 03:24 PM
|
|||
|
|||
Help Needed
HI
I have a question someone may be able to help with. Im currentl running a 20% Glass Filled pp using a valve gate system. The problem is I keep getting voids at the gate unless I hold the gate open to allow cooling of the gate. My mould runs at 55 F and I have had to increase cycle by 30 secs. any input would be helpfull Thanks djmllr 
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
